Software
Servicios
Recursos
The Manufacturing Quality Pack unites simulation, correction, and deviation analysis into one coherent workflow — reducing rework, stabilizing processes, and cutting industrialization time.
It helps manufacturers anticipate deformation, correct machining issues faster, and understand deviations clearly — turning disconnected design, production, and inspection steps into one continuous feedback loop.
Design validates tolerances. Production applies corrections by feel. Quality writes reports nobody acts on.
Measurement data exists — it just never reaches the CNC in the right form.
Validates tolerances and machining strategies — but results never feed back into production.
Applies corrections by feel. Trial-and-error loops delay stable output. Scrap accumulates.
Writes deviation reports nobody acts on. Data stays in metrology — it never closes the loop.
The Manufacturing Quality Pack connects the three steps that have always been disconnected.
Before production. Virtually simulate deformation and validate your tolerance strategy on CAD — before a single chip is cut.
Instantly, from measurement. Transform deviations into exact CNC corrections automatically — no guesswork, no trial-and-error.
Root causes, not symptoms. Break any deviation into form, size, orientation, and position — in one click, in 3D.
Virtually test geometric deformation scenarios on your CAD model before machining begins. Simulate form, size, orientation, and position defects — and confirm your tolerance strategy holds before producing a single physical part.
“Fail virtually, not on the shop floor.”
Transform measured deviations into CNC corrections automatically — tool offsets, work references, axis corrections. Predictive Mode shows how the next part will measure before you run it.
“From deviation to correction — automatically.”
Automatically break down any deviation into form, size, orientation, and position components — in a single click, in 3D, directly on the part geometry. Based on ISO 20170.
“No more guessing — just clear root causes.”
“Before, I'd measure a part, get a deviation report, and spend two hours trying to figure out which offset to change. Now I look at the decomposition view, see it's a position issue not a form issue, and the corrector gives me the exact adjustment. I ran my first part-to-stable cycle in one shift instead of three.”
See the Manufacturing Quality Pack on your own parts in 30 minutes.
"*" señala los campos obligatorios
NOVEDAD: Inspection Flow ya está disponible. Centralice sus datos y tome el control de su flujo de calidad.